Notice:Before every riding,and after every 25-45 miles,we advise following the pre-riding safety checklist in the table below.
Safety Check | Basic Steps |
|
♦Ensure front and rear brakes work properly ♦ Check brake pads for wear and ensure they are not over-worn ♦ Ensure brake pads are correctly positioned in relation to the rims ♦ Ensure brake control cables are lubricated,correctly adjusted,and display no obvious wear.Ensure brake control severs are lubricated and tightly secured to the handlebars ♦ Test brake levers are firm and that brake,motor cutoff functions,and brake light are functioning properly |
|
♦ Ensure tires are inflated to within the recommended limits displayed on the tire sidewalls and holding air ♦ Ensure tires have good tread,have no bulges or excessive wear,and are free from any other damage. ♦ Ensure rims run true and have no obvious wobbles, dents,or kinks. ♦ Ensure all wheel spokes are tight and not broken ♦ Check axle nuts and front wheel quick release skewer is correctly tension, fully closed,and secure position. |
|
♦ Ensure handlebar and stem are correctly adjusted and tightened and allow proper steering ♦ Ensure the handlebar is set correctly in relation to the forks and the direction of travel |
|
♦ Ensure the chain is oiled,clean,and runs smoothly ♦ Extra care is required in wet.salty/otherwise corrosive,or dusty conditions |
5.Bearings |
♦ Ensure all bearings are lubricated,run freely,and display no excess movement grinding,or rattling ♦ Check headset,wheel bearings,pedal bearings,and bottom bracket bearings |
6.Cranks and Pedals |
♦ Ensure pedals are securely tightened to the cranks ♦ Ensure the cranks are securely tightened and are not bent |
|
♦ Check that the derailleur is adjusted and functioning properly ♦ Ensure shifter and brake levers are attached to the handlebar securely ♦ Ensure all brake and shift cables are properly lubricated |
|
♦ Check that the frame and fork are not bent or broken ♦ If either frame or fork are bent or broken,they should be replaced ♦ Check that the seat is adjusted,properly and seat post quick release lever is securely tightened |
|
♦ Ensure hub motor is spinning smoothly and motor bearings are in good working order ♦ Ensure all power cables running to hub motor are secured and undamaged ♦ Make sure the hub motor axle bolts are secured and all torque arms and torque washers are in place |
10.Battery |
♦ Ensure battery is charged before use ♦ Ensure there is no damage to battery ♦ Lock battery to frame and check to see that it is secured ♦ Charge and store bike and battery in a dry location,between 50*F-77*F ♦ Let bike dry completely for using again |
11.Electrical Cables |
♦ Look over connectors to make sure they are fully seated,free from debris or moisture ♦ Check cables and cable housing for obvious signs of damage ♦ Ensure headlight,taillight,and brake light are functioning adjusted properly,and unobstructed |
12.Accessories |
♦ Ensure all reflectors are properly fitted and not obscured ♦ Ensure all other fittings on bike are properly secured and functioning ♦ Inspect helmet and other safety gear for signs of damage ♦ Ensure rider is wearing helmet and other required riding safety gear ♦ Ensure mounting hardware is properly secured if fitted with rear rack ♦ Ensure taillight and taillight power wire are properly secured if fitted with rear rack ♦ Ensure fender mounting hardware is properly secured if fitted with fenders ♦ Ensure there are no cracks or holes in fenders if fitted with fenders |